help!!

[ristuuk]

Got a problem with one of my Vx's.
Its a mx12 and the t bar has deceided to separate from the body. its a low break in the yoke . super glue no good since it has been used before and the break is now not clean. any suggestions?
Thinking about drilling the stem out and rodding it, but not sure how far I can drill down into the base.

[Anyone]

hve you tried epoxy glue ???

[ToddGraft]

or open the box?

[ristuuk]

opening the box means taking 4 of the boards out which I dont like messing with those things, It wont drill out so I suppose its the old araldite. hope fully it wont glue the whole mechanism up.
In an hour or two I may have a one channel vision mixer for sale.

[ToddGraft]

Ya don't have a choice!
It's like riding a bike and the chain keeps comin off
or
like puttin on a used condom
You will never get up to speed or have the proper thrust

Happened to me years ago and a pro fix was needed
I always use a bit of foam in the crack to help protect those uncontollable mixing urges.

Open the box, its cheaper an you will learn more.

[ristuuk]

Yep Ill have to open the box.
dont fancy the used condom idea.

[ToddGraft]

If anyone is on my doorstep?
I've got a microtouch flatscreen that needs a look at, yes I've opened the box and it lost its warranty ages ago.
Think its a cracked joint and it used to respond when twisted.
This kind of fault is up in the air so if there is a keen electronics geek (LONDON)........ I can start scratchin again.

[ristuuk]

I'll do that *****...soon as i get a break...im in corporate hell for the next 6 weeks!!